MINI 1 CH DC 12V RF radio remote control switch with 1 transmitter & 12 receivers 1000M for home automation. 1 CH RF remote control system kit with 12 receivers DC 12V for electrical appliances 315MHz. This 1 channel DC RF wireless remote control system can used to control lights, motor, fans, electrically operated doors/locks blinds or other appliances automatically.It is easy to install and use. The remote control switch has 12 buttons, and works with toggle, momentary 2 control modes. Its control distance is about 1000 meters away.
It should be a good choice for you. Note: Customized design is acceptable, we have professional technology-support! Wireless control, easy to install. Control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with AC 110240V or DC 028V.
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors. With characteristics of over current protection, short-circuit protection and temperature protection. Use microcontroller model of EM78P156, an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology. Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code. One/several transmitters can control one/several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes. Transmitting Frequency: The default frequency is 315MHz. Control Modes: Toggle, Momentary, latched.Working Voltage Range of Relay: AC 110240V or DC 028V. PCB size: 44mm x33mm x 19mm. Case size: 54mm x 38mm x 27mm. Remote Control Distance: 1000m / 3000ft (theoretically). Encode: Fixed code by Soldering.
Unit size: 145mm x 44mm x 25mm. Power Supply:1 x 6F22 -9V battery (included, can be used for 12 months). If you want to use other control modes, do as following operation. Setting control mode Toggle: Disconnect Jumper. Setting control mode Toggle: Only connect Jumper-2.Control mode Toggle: Press -> On; Press again -> Off. Press button 1: Turn on the relay (connect B and C, disconnect A and B) Press button 1 again: Turn off the relay (disconnect B and C, connect A and B). Setting control mode Momentary: Connect Jumper. Control mode Momentary: Press and hold -> On; Release -> Off.
Press and hold button 1: Turn on the relay (connect B and C, disconnect A and B) Release button 1: Turn off the relay (disconnect B and C, connect A and B). 12 x Receiver: M1-DC12 (1 Channel / Three Control Modes). We don't accept the cheque. The images are for reference only. Please take the item you get as the standard.
Please repack the item carefully. During our weekend, you can get the reply in 48 hours.If you we are not satisfied with the product or service , please contact me and don't give us negative or natural feedback, We must give you a satisfactory solution. Your action will help us offer our milk and bread.
The item "DIY RF 12x1CH way Remote Control Switch Relay on/off Wireless Light led DC9V/12V" is in sale since Friday, April 11, 2014. This item is in the category "Consumer Electronics\Surveillance & Smart Home Electronics\Other Smart Home Electronics".
The seller is "13yuanyuan" and is located in , . This item can be shipped worldwide.