Wireless Remote Control

Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver


Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver
Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver
Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver

Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver    Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver
WINCH WIRELESS REMOTE CONTROL TWIN HANDSET 24V 24 VOLT EXTERNAL MOUNT RECEIVER. Premium winches & auto accessories.

The original orange pulling machine. SAME DAY DISPATCH ON ORDERS RECEIVED BEFORE 2PM.

SEE WINCHMAX WEBSITE FOR DETAILS. UK based supply and service.

24V wireless remote kit with twin transmitters and standalone receiver. Designed for use with electric winches, but could be used for any application where a two-channel low current 24V control signal is required. Robust waterproof receiver unit sealed and encased for external mounting ideal for quad bike, 4X4 & recovery truck winches.

Supplied with connection harness complete with male / female four pin connector allows easy installation and removal of receiver for convenience or security. Improved components, Improved reliability, Improved range. Latest heavy duty long range model. Free- Fitted Battery in remotes.

Heat shielded cables with pre-fitted heat shrink insulated terminals for easy fitting. We are so confident in the quality we are even prepared to give you a two-year guarantee! Once you have used a wireless remote you will never want to be without one again, an absolute must have for any recovery or off roading operations.

You can operate the winch from a safe distance and when recovering vehicles, you can steer them while operating the winch from inside at the same time. No need to stand out in the rain! Each remote is uniquely coded to the transmitter to ensure there is no possibility of interference from other transmitters.

It is very simple to install in just a few minutes. Winchmax External Remote Control Instructions. Please install as per installation diagram and instructions. To turn your remote control on press and hold both the IN and OUT buttons until the constant blue light appears. The remote control is now active hold either the IN or OUT button to operate. When you have finished using the device push and hold both the IN and OUT buttons until the blue light disappears. Your remote control is now turned off. IMPORTANT: WHEN FITTING WIRELESS CONTROL SYSTEM IT IS ESSENTIAL THAT YOU ALSO INSTALL A BATTERY ISOLATOR TO PREVENT THE POSSIBILITY OF ACCIDENTAL STARTING WHEN THE WINCH IS UNATTENDED.

This should provide many years of trouble free operation, however it is essential that it is correctly installed otherwise irreparable damage to the micro circuitry will be caused. The basic principle of operation is that once connected to a power supply, the two output wires of the receiver will go to the supply voltage (12v or 24v depending on the model) when the corresponding button on the transmitter (hand set) is pressed.

The output can then be used to operate the trigger terminals on a secondary contactor (solenoid) to switch the main load e. The outputs MUST NEVER be connected to earth as otherwise they will short circuit and burn out. If you have any doubt about which are the trigger terminals on your solenoid, first check by using a thin piece of wire connected to the positive supply, when you apply it to one of the solenoid trigger terminals the winch should run in one direction, if you apply it to the trigger terminal it should operate in the opposite direction.

In most cases winches are fitted with a plug in wander lead, at the back of the wander lead socket you will see three wires. One of the wires is the positive feed to the wander lead switch, depending on which way the switch is pressed this feed will then be diverted down one of the other two wires (the output wires) which will in turn be connected to the trigger terminal of the solenoid. There are many different types of control configurations, but if you understand the basic principle of operation this should allow you to apply it to whichever set you have.

We have provided a schematic of the most common single solenoid pack winch control system (in our diagram trigger terminals on the solenoid are labelled as 1 & 3) but if you have any doubt as to how you should connect your remote DO NOT do it before consulting our office hours helpline for advice. (see contact details link at bottom of listing). Twin SL Handsets, Long Range With Enclosure. 2 Channel Winch Remote Control, Wireless. Single HD Handset, Long Range.

Twin HD Handsets, Long Range. Here at the Winch Shop we are all dedicated winch enthusiasts. Our aim to bring you top quality products at reasonable prices. We work very hard to make sure we deliver customer service above and beyond industry standards.

The item "WINCH WIRELESS REMOTE CONTROL TWIN HANDSET 24V 24 VOLT EXTERNAL MOUNT RECEIVER" is in sale since Friday, April 7, 2017. This item is in the category "Vehicle Parts & Accessories\Disabled Vehicle Parts". The seller is "integratas" and is located in Bungay.

This item can be shipped worldwide.

  1. Manufacturer Part Number: WMEXTREMKIT24V
  2. Brand: Winchmax


Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver    Winch Wireless Remote Control Twin Handset 24v 24 Volt External Mount Receiver