Wireless Remote Control Dog Training Shock Collar Electric Fence Rechargeable SM. Emission Frequency: 433.825 MHz. Charging the remote and receiver. Both the remote and receiver use lithium batteries that can be recharged. For best results, please charge the remote and the receiver for 3-4 hours each before using the first time.There are 4 bars to show the battery power level. 4 bars means the remote is fully charged. When charging, the red LED will light up. Full Charged, the light goes off. Choosing the appropriate length of contact points. This is a critical step and is often overlooked. If you don't have the proper length contact points, the collar won't work correctly. For smaller dogs, the short contact points should be used. For larger dogs, or dogs with a heavier hair coat, you should use the longer contact points. Fit the collar to your dog. The collar needs to be placed relatively high on the dog's neck. Usually just a couple of inches below the ears. The collar should be pretty snug on the dog's neck, and it should not dangle. If the collar is too loose, the contact points will not be touching your dog, and it will not work.
A good indicator that the collar is fit properly is if you can fit two fingers under the collar. Press Dog logo on the remote to choose from A and B. Press and hold the switch on collar until you hear a beep and a green light starts to flash quickly.
Press Y button on the remote to finish matching process. Match one collar to A and the other to B if you are training two dogs. How to use the test light. Hold the test light contacts to the contact points. Shift to shock mode and press Y button on remote.The test light will flash if the unit runs well. If the light does not flash, recharge the collar and re-test it.
Contact with customer service for help if the problem remains. How to find the best vibration / shock level. The unit comes with up and down buttons to control the vibration / shock level, with 1 as the lowest and 8 as the highest. The appropriate vibration / shock level depends on your dog's weight, temperament and threshold for vibration / shock.
Always start from the lowest to the highest level. The appropriate level could be found when the dog responds with a mild reaction, such as a tensing of the neck muscles. The vibration / shock level may vary depending on the training situation.When highly distracted, a higher level may be needed to get his/her attention. How to maximize the control distance. The unit has a 800 meters control range. The range may depending on the way the remote is held. Hold it away from your body to get a larger range. Keep the device full charged for a maximum signal strength. Eliminate one misbehavior or teach one obedience command at a time. If you move too fast with training, your dog may feel confused. Correct your dog ever time he / she misbehaves. Unless you can supervise him /her, it is recommended that you restrict your dog from situations in which he / she has a history of misbehaving.
However, setting up a situation as a training session can dramatically improve your chance of success. If your dog reacts to the tones by hiding or acting fearful, redirect his attention to a simple and appropriate behavior, such as the "sit" command.
Dogs should be at least 6 months old before using the training collar. This is not a toy. Keep it away from children or irresponsible family members. Other pets in hearing rage would be affected by the training tones. Therefore training sessions should be conducted out of hearing range of other pets.
Never use the product to correct or eliminate any form of aggressive behavior. Contact your local veterinarian or professional trainer to determine if your dog is aggressive. Is the vibration/ shock safe for my dog? Yes, it is harmless to your dog. Electronic training devices require interaction and training from the owner to achieve desired results.
How old does my dog have to be to use the device? Your dog should be able to recognize basic obedience commands such as sit and stay.
Dogs should be at least 6 months old to use the device. Once my dog is trained and has been obeying my commands, will he have to continue to wear the collar? But you may need to reinforce training with the collar from time to time. Will I get exactly 800 meters of control range with it?The range will vary according to terrain, weather, vegetation, as well as transmission from other radio devices. Keep the device full charged from a maximum signal strength. My dog does not respond when I press a button. Make sure the remote and the collar have been turned on. Make sure there's enough power in the remote and collar. Terrain, weather, vegetation, transmission from other radio devices and some other factors may impact the amount of range you have with the unit.
Test the collar referring to "How to use the test light". Increase the vibration/ shock level. Make sure the contact points on the collar are placed appropriately.
The collar will not turn on. Make sure the collar has been charged. The initial charge time should be 4 hours. Subsequent charges would take 2-3 hours.The collar is not responding to the remote. Make sure the collar is charged and switched on. Check the screen on remote and make sure you are sending signals to the right collar. Make sure the collar is paired with the remote correctly. 1 x Wireless Remote Control. 1 x Dog Training Shock Collar. We are here to assist you as always. Please make sure your address is correct. If the item arrives to you in a non-working condition or is misrepresented. Nothing would be the trouble.
Most problem would be solved well on the base of friendly communicate. Please read the item description and see if the item fits your vehicle exactly. Saturday, Sunday, and Holiday : Closed. The item "Dog Training Shock Collar Electric Wireless Remote Control Fence Rechargeable US" is in sale since Sunday, July 8, 2018.This item is in the category "Pet Supplies\Dog Supplies\Training & Obedience\Bark Collars". The seller is "beliebtt" and is located in Walnut, California. This item can be shipped to United States.